Forums

Home Forums General Configuration Local split tunneling for VPN VLAN

Local split tunneling for VPN VLAN

This topic contains 2 replies, has 2 voices, and was last updated by  moral 5 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #4797

    moral
    Participant

    Would the correct method to allow LAN devices to communicate with devices on a VLAN with VPN active be to add the local IP ranges to the split tunneling setting as follows?

    Tunnel everything through VPN except the domains and IP ranges listed below:
    192.168.10.1/255

    Thank you

    #4805

    support
    Participant

    Split tunneling is not needed if the case is a device on one VLAN talking to a device on another VLAN. For that, you need to configure the VLAN communications matrix on the Network Settings page (v2.4.5 and above).

    #4807

    moral
    Participant

    ok! Thank you!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.